79
Enable Port 9100 as additional support for HTTP (IPP) printing
1. Open your Web browser and enter the TCP/IP address of the machine in the Address or Location field.
Press [Enter].
2. Click the [Properties] tab.
3. Enter the Administrator User name and password if prompted. The default is [admin] and [1111].
4. Click the symbol to the left of [Connectivity].
5. Click the symbol to the left of [Protocols].
6. Select [Raw TCP/IP Printing] in the directory tree.
7. Ensure the [Enabled] box is checked to enable Raw TCP/IP Printing.
8. Leave the [TCP Port Number] set to 9100 for Port 1. If two additional ports are available, click [Default
All] to see if they set to 9101 and 9102 respectively (emulating HP JetDirect EX Plus 3).
9. Leave the [Bidirectional] and [Maximum Connections] settings at their default values.
10. Set the [End of Job Timeout] to the number of seconds to wait before processing a job without an End
Of Job indicator.
11. Leave the [PDL Switching] Enabled box at its default value.
12. Click [Apply] to accept the changes.
NOTE: The settings are not applied until you restart the machine.
13. Click the [Status Tab] link.
14. Click the [Reboot Machine] button to reboot the machine. The network controller takes approximately 5
minutes to reboot and network connectivity will be unavailable during this time.
To Next Page
Loading...
