XIEGU X108 - Function Operation Guide

3.3
Functions Operating Instructions
3.3.1:
Set the current operating frequency
Method 1
: Press the front panel UP / DN button, move to the desired frequency step
bit, then
rotate the frequency knob to change the current frequency value.
Method 2
: On the multifunction digital microphone in hand, Press
and then enter the frequency directly, such as: 14.27
then press the F-
INP ENT button again to complete the frequency
3.3.2: Mode Switching
Method 1
: Press the frequency knob to switch the current menu page, then press [MODE].
Press corresponding multifunction button, to complete mode switching.
Method 2
: On the multifunction digital microphone in hand, press
to complete the mode switching.
3.3.3: Filter Switching
Method 1: Press the
frequency knob to switch the current menu page, then press [BW].
Press corresponding multifunction button to complete filter switching.
Method 2
: On the multifunction digital
to complete filter switching.
3.3.4: Preamplifier on/off
Press the frequency knob to switch the current menu page, then press [
When the preamplifier is on, PRE will be highlighted green. When the preamplifier
PRE will appear dark.
3.3.5: Attenuator on/off
Press the frequency knob to switch the current menu page, then press [
When the attenuator is on, ATT will be highlighted green. When the attenuator
7 / 12
Functions Operating Instructions
Set the current operating frequency
: Press the front panel UP / DN button, move to the desired frequency step
rotate the frequency knob to change the current frequency value.
: On the multifunction digital microphone in hand, Press
and then enter the frequency directly, such as: 14.27
INP ENT button again to complete the frequency
settings.
: Press the frequency knob to switch the current menu page, then press [MODE].
Press corresponding multifunction button, to complete mode switching.
: On the multifunction digital microphone in hand, press
to complete the mode switching.
frequency knob to switch the current menu page, then press [BW].
Press corresponding multifunction button to complete filter switching.
: On the multifunction digital
microphone in hand, press
Press the frequency knob to switch the current menu page, then press [
When the preamplifier is on, PRE will be highlighted green. When the preamplifier
Press the frequency knob to switch the current menu page, then press [
When the attenuator is on, ATT will be highlighted green. When the attenuator
: Press the front panel UP / DN button, move to the desired frequency step
-bit
rotate the frequency knob to change the current frequency value.
settings.
: Press the frequency knob to switch the current menu page, then press [MODE].
Press corresponding multifunction button, to complete mode switching.
frequency knob to switch the current menu page, then press [BW].
Press corresponding multifunction button to complete filter switching.
Press the frequency knob to switch the current menu page, then press [
PRE].
When the preamplifier is on, PRE will be highlighted green. When the preamplifier
is off,
Press the frequency knob to switch the current menu page, then press [
ATT].
When the attenuator is on, ATT will be highlighted green. When the attenuator
is off,