XIEGU X108 - Page 8

8 / 12
ATT will appear dark. The attenuator provides 10 dB attenuation.
3.3.6: Automatic Gain Control on/off
Press the frequency knob to switch the current menu page, then press [AGC].
AGC options are Fast or Slow with the screen showing the current status. Press [AGC] again
to exit.
3.3.7: Noise Blanker on/off (if equipped)
Press the frequency knob to switch the current menu page, then press [NB]. The Noise
Blanker offers depth of NB1 thru NB4, with the screen showing the current status.
3.3.8: Switching between VFO-A / VFO-B
Press the frequency knob to switch the current menu page, then press [A/B]. You can toggle
between VFO-A and VFO-B.
3.3.9: Set both VFO's to the same settings
Press the frequency knob to switch the current menu page, then press [A=B]. The settings
of the current VFO will transfer to the second VFO.
3.3.10: Split frequency operations
Press the frequency knob to switch the current menu page, then press [SPLIT].
The radio will receive on VFO-A and transmit on VFO-B.
3.3.11: RIT tuning
Press the frequency knob to switch the current menu page, then press [RIT].
Turning the frequency knob will change the receive frequency but leave the
transmit frequency unchanged. Pressing [RIT] again will exit this mode.
3.3.12: Transmit power setting
Press the frequency knob to switch the current menu page, then press [POW].
The on-screen power status will be highlighted. Rotate the frequency knob to select the