XIEGU X108G - Memory Management and System Settings; Memory, Keying, and Time; Squelch, Compression, and Software

9
3.2.15: Save current settings to Memory
Press the frequency knob to switch the current menu page, then press [V/M] to choose channel mode.
Turn the frequency knob until “BLANK” is highlighted. Press [MW] to return to frequency mode.
In the lower left corner of the screen will be the symbol "CH***", flashing..Adjust frequency,
operating mode and other parameters desired, then press [MW] to write this information to memory.
3.2.16: Delete the current channel
Press the frequency knob to switch the current menu page, then press [MC] to clear the information
stored in the current channel.
3.2.17: Manual / automatic telegraph key
Press the frequency knob to switch the current menu page, then press [KEY].
Choose Manual Key, Automatic Left Hand telegraph key or Automatic Right Hand telegraph key.
3.2.18: Automatic telegraph key rate
Press the frequency knob to switch the current menu page, then press [KSPD], via the [UP/DOWN]
knob to set the automatic key rate.
3.2.19: Set the local time
Press the frequency knob to switch the current menu page, then press [TIME].
Then press the corresponding number keys on the microphone to set the local time.
3.2.20: Setting squelch level
Press the frequency knob to switch the current menu page, then press [SQL], press the [UP/DOWN]
knob to set the squelch depth and save the squelch setting.
3.2.21: Set voice (speech) compression ratio
Press the frequency knob to switch the current menu page, then press [CMP]. Adjust the
compression ratio as desired.
3.2.22: HRD Software
When you connect your computer via HRD, you can select IC7000 model.