XIEGU X108G - Page 14

13
n After setting, press [save] key to save and exit setup.
n If press Exit , not save and exit setup.
3.4.2 user-defined on call sign display
X108G can display of custom boot interface information. The system default display is “XIEGU”,
Users can customize this content. The method is as follows:
a. In the shutdown state, hold down the F3 key, and then turn on your X108G
b. use the frequency knob to adjust the display character, press the frequency knob to determine the
current state
c. after the setting, press [SAVE] to exit.
3.4.3 ADC on the system check value (Please Note: It is strictly prohibited to modify or delete
the data!!)
In shutdown state, hold down the F2 key, turn on your X108G, you can see setting interface for ADC
check value of the system. The data in this interface is related to the accuracy of the S table. It is
strictly prohibited to modify or delete the data!! Otherwise it will cause the S table display is
not accurate or S table does not show.