EasyManuals Logo

Xilinx Alveo U250 Getting Started Guide

Xilinx Alveo U250
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
11. You will be asked to conrm the update, as shown below. Type y and enter.
Probing card[0]: DSA on FPGA needs updating
DSA on below boards will be updated:
Card [0]
Are you sure you wish to proceed? [y/n]
Flashing will take up to 10 minutes. Successfully ashing a new card results in a message
similar to the one shown below. If you do not see one, refer to Chapter 7: Troubleshoong.
Updating DSA on card[0]
INFO: ***Found 880 ELA Records
Idcode byte[0] ff
Idcode byte[1] 20
Idcode byte[2] bb
Idcode byte[3] 21
Idcode byte[4] 10
Enabled bitstream guard. Bitstream will not be loaded until flashing is
finished.
Erasing flash............................................
Programming flash............................................
Cleared bitstream guard. Bitstream now active.
1 Card(s) flashed succesfully
Cold reboot machine to load the new image on FPGA
If you have previously upgraded the card, you will see a message similar to the following:
Probing card[0]: DSA on FPGA is up-to-date
0 Card(s) flashed successfully.
12. Cold boot your machine to load the new rmware image on the FPGA.
IMPORTANT
! Be sure to fully power o the machine and then power it on again. The image will not
boot from ash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image ash ne
démarrera pas si la machine n'est pas redémarrée.
Wichg! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash,
wenn der Computer nur neu gestartet wird.
The installaon for deployment is now complete. You can go directly to Chapter 5: Card Bring-Up
and Validaon to validate the installaon.
XRT and Deployment Shell Installation
Procedures on Ubuntu
Use the following steps to download and install the soware using an RPM installaon package.
For details on upgrading or downgrading the XRT and deployment shell, see Upgrading,
Downgrading, and Uninstalling XRT and Deployment Shell on Ubuntu.
Chapter 4: Installing the Deployment Software
UG1301 (v1.3) February 12, 2019 www.xilinx.com
Getting Started with Alveo Accelerator Cards 23
Send Feedback

Other manuals for Xilinx Alveo U250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xilinx Alveo U250 and is the answer not in the manual?

Xilinx Alveo U250 Specifications

General IconGeneral
BrandXilinx
ModelAlveo U250
CategoryComputer Hardware
LanguageEnglish

Related product manuals