Xilinx Alveo U250 Getting Started Guide

IMPORTANT! Be sure to fully power o the machine and then power it on again. The image will not
boot from ash if the machine is only rebooted.
IMPORTANT! Assurez-vous d'éteindre complètement la machine, puis de la rallumer. L'image ash ne
démarrera pas si la machine n'est pas redémarrée.
Wichg! Schalten Sie das Gerät vollständig aus und wieder ein. Das Image startet nicht von Flash,
wenn der Computer nur neu gestartet wird.
The installaon for deployment is now complete. You can go directly to Chapter 5: Card Bring-Up
and Validaon to validate the installaon.
Upgrading, Downgrading, and Uninstalling
XRT and Deployment Shell on RedHat and
CentOS
During upgrading, downgrading, or uninstalling, it can be useful to list the currently installed
Alveo packages.
To list the currently installed deployment shell package, run the following command in a Linux
terminal:
$ yum list installed | grep xilinx
To list the currently installed XRT package, run the following command:
$ yum list installed | grep xrt
Upgrading Packages
You can upgrade the XRT and deployment shell on your Alveo card by following these steps.
Both packages must be upgraded concurrently.
1. Download the desired XRT and deployment shell packages. Both must be from the same
release (i.e. both are 2018.2 package releases).
2. Install the XRT installaon package using the following command, where <rpm-dir> is the
directory where the packages were downloaded in the previous step and <version> is the
laer part of the XRT le name.
$ sudo yum install <rpm-dir>/xrt_<version>.rpm
This will install the XRT along with any necessary dependencies. Follow the instrucons
when prompted throughout the installaon.
Chapter 4: Installing the Deployment Software
UG1301 (v1.3) February 12, 2019 www.xilinx.com
Getting Started with Alveo Accelerator Cards 26
Send Feedback

Xilinx Alveo U250 Specifications

General

Brand	Xilinx
Model	Alveo U250
Category	Computer Hardware
Language	English