Xilinx KC705 Getting Started

14 www.xilinx.com KC705 Getting Started Guide
UG913 (v1.0.1) May 31, 2012
Chapter 1: Getting Started with the Kintex-7 FPGA KC705 Embedded Kit
10. Repeat step 7, step 8, and step 9 to explore different VIDEO DEMO TESTS options by
changing the selections mentioned in step 7.
Running BIST tests
11. A Web server-based BIST demonstration can also be run on the same hardware to test
different peripherals. Enter these commands at the XMD prompt to run the BIST
demonstration:
XMD% stop
XMD% dow Bist.elf
XMD% con
12. Reload the Web page with the same URL (192.168.1.10). The Web page should appear
as shown in Figure 1-7.
13. The left side of the Web page has different options for selecting the type of test to run
on the hardware. For running the test, select any option from the list and press the Go
Target button. The right side of the Web page has a messaging section that prints the
results of the tests.
The Video and BIST demonstrations using the KC705 board are complete. Because a fully
configured MicroBlaze processor subsystem has been provided, the user can start
developing embedded applications. Because an FPGA is being used, the processor
subsystem can also be fully customized. To do this, the ISE Design Suite and the
USB-UART driver must be installed on the computer (see Appendix C, Installation and
Licensing of ISE Design Suite).
X-Ref Target - Figure 1-7
Figure 1-7: BIST Demonstration Web Page with DDR3 test results
UG913_c1_07_051612

Xilinx KC705 Specifications

General

Brand	Xilinx
Model	KC705
Category	Motherboard
Language	English