130 www.xilinx.com Ethernet 1000BASE-X PCS/PMA or SGMII v9.1
UG155 March 24, 2008
Chapter 9: Configuration and Status
R
Register 0: Control Register
MDIO Register 0: Control Register
Table 9-14: Control Register (Register 0)
Bit(s) Name Description Attributes
Default
Value
0.15 Reset 1 = PCS/PMA reset
0 = Normal Operation
read/write
self clearing
0
0.14 Loopback 1 = Enable Loopback Mode
0 = Disable Loopback Mode
When used with a RocketIO transceiver,
the core is placed in internal loopback
mode.
With the TBI version, Bit 1 is connected to
ewrap. When set to ‘1’ indicates to the
external PMA module to enter loopback
mode.
See “Loopback,” page 197.
read/write 0
0.13 Speed
Selection
(LSB)
Always returns a 0 for this bit. Together
with bit 0.6, speed selection of 1000 Mbps
is identified.
returns 0 0
0.12 Auto-
Negotiation
Enable
Ignore this bit because Auto-Negotiation
is not included.
read/ write 1
0.11 Power Down 1 = Power down
0 = Normal operation
With the PMA option, when set to ’1’ the
RocketIO transceiver is placed in a low-
power state. This bit requires a reset (see
bit 0.15) to clear.
With the TBI version this register bit has
no effect.
read/ write 0
0.10 Isolate 1 = Electrically Isolate PHY from GMII
0 = Normal operation
read/write 1
RESET
LOOPBACK
AUTO-NEG ENABLE
RESTART AUTO-NEG
RESERVED
POWER DOWN
SPEED
SPEED
15 14 13 12 11 10 7 6 5 0
Reg 0
ISOLATE
9
8
DUPLEX MODE
COLLISION TEST
4
UNIDIRECTIONAL ENABLE
To Next Page
Loading...