Xinje DS3 Series Manual

99
error
02
0
E-020
Parameter
loading error
Parameter
self-checking cannot
pass
Re-power the servo to restore
default setting or contact us
1
E-021
Parameter out
of range
The setting value out
of range
Check the parameters and set
again
2
E-022
Parameter
conflict
TREF or VREF
function setting
conflict
Check the TREF or VREF
setting
3
E-023
Sampling
channel
setting error
User-defined output
trigger channel or
data monitor channel
setting error
Check the setting parameter
4
E-024
Parameter
lost
Power supply
voltage too low
1.for single phase 220V,
connect L1, L3
2. power on at once after cut
power supply it will show
E-024
3. set the parameter again
5
E-025
Erase flash
error
Parameter store error
when power off
Contact us
6
E-026
Initialize
flash error
Flash chip power
supply not stable
Contact us
03
0
E-030
Bus
overvoltage
(220V: U0-05
≥390 alarm,
380V: U0-05
power grid voltage
too high
Check the power supply, 220V
servo drive voltage range is
200V~240V, 380V servo drive
voltage range is 360~420V,
please use regulator and

Xinje DS3 Series Specifications

General

Brand	Xinje
Model	DS3 Series
Category	Servo Drives
Language	English