Appendix 2 instructions list
Appendix 2-1．Basic Instructions List
Mnemonic Function
LD
Initial logical operation contact type NO (normally open)
LDI
Initial logical operation contact type NC (normally closed)
OUT
Final logic operation type coil drive
AND Serial connection of NO
ANI Serial connection of NC
OR Parallel connection of NO
ORI Parallel connection of NC
LDP Rising edge pulse
LDF Falling edge pulse
ANDP Serial connection of rising edge pulse
ANDF Serial connection of falling edge pulse
ORP Parallel connection of rising edge pulse
ORF Parallel connection of falling edge pulse
LDD Read the point
LDDI Read NC
ANDD Read the point and serial connection
ANDDI Read NC and serial connection
ORD Read the point and parallel connection
ORDI Read NC and parallel connection
OUTD Output the point
ORB Parallel connection of parallel multiply parallel circuit
ANB Serial connection of parallel multiply parallel circuit
MCS New bus line start
MCR Bus line return
ALT Alternate state
PLS Rising edge pulse
PLF Falling edge pulse
SET Set a bit device permanently on
RST Reset a bit device permanently off
OUT Output counter coil
RST Output reset, and current data reset to zero
END I/O process and return to step0
GROUP Instruction block fold start
GROUPE Instruction block fold end
TMR Time
To Next Page
Loading...
Need help?
General
