9 change the soft components
Continue to click it, the replacement window will pop up:
As in the above graphs, we need only 5 minutes replace I/O terminals. This method avoids us
to modify the program, change PLC etc.
※1: after modification, make sure to restart PLC
In the pop-up window,
click X2, disable the
faulty terminal X2
In the pop-up window,
click X4, replace the
faulty terminal X2 with
X4
Click “Replace”, the
status table will change,
the original X2 changes
to be , which
means X2 has been
disabled.
To Next Page
Loading...
