Wireless Access Point
98 Viewing Status on the Wireless AP
Bond Settings Summary
This section provides information about the relationship that has been
selected for the Gigabit ports. For detailed explanations and to make
configuration changes, see “Bonds and Bridging” on page 173.
• Bond: Lists all network bonds that have been configured.
• Mode: Shows the type of relationship that has been selected for the
Gigabit ports.
• Ports: Shows the Gigabit ports that are part of this bond.
• Port Mode: Shows the relationship that has been selected for the
Ethernet ports. See “Bonds and Bridging” on page 173 for details
• Active VLANs: Shows the VLANs that are active in this bond.
• Mirror: Shows whether mirroring is enabled on this bond.
IAP Section
This section provides information about the Integrated Access Points
(IAPs) that are contained within the AP. How many IAPs are listed
depends on which product model you are using. To make configuration
changes to these IAPs, go to “IAP Settings” on page 312.
• IAP: Lists the IAPs that are available on the AP.
• State: Shows the current state of each IAP, either up or down. IAPs
that are down are shown in RED. Figure 45 shows an example where
iap7 is down.
• AP Type: Shows the types of 802.11 clients supported by this IAP (11/
a/b/g/n) and the number of separate data streams transmitted and
received by the antennas of each IAP for 802.11n. For example, 3x3
means that the IAP supports three transmit chains and three receive
chains. See “Up to Eight Simultaneous Data Streams — Spatial
Multiplexing” on page 44.
To Next Page
Loading...
