Wireless Access Point
492 The Command Line Interface
uptime
The uptime command [MyAP(config)# uptime] is used to display the elapsed
time since you last rebooted the AP.
vlan
The vlan command [MyAP(config-vlan)#] is used to establish your VLAN
parameters.
edit Modify an existing tunnel.
FORMAT:
tunnel edit [existingtunnel]
reset Delete all existing tunnels.
FORMAT:
tunnel reset
Command Description
continuous Continuously update information.
<cr> Display time since last reboot.
FORMAT:
uptime
Command Description
add Add a VLAN.
FORMAT:
vlan add [newvlan]
Command Description
To Next Page
Loading...
Need help?
General
