Wireless Access Point
Configuring the Wireless AP 399
Clusters
Clusters allow you to configure multiple APs at the same time. Using WMI (or
CLI), you may define a set of APs that are members of the cluster. Then you may
enter Cluster mode for a selected cluster, which sends all successive configuration
commands issued via CLI or WMI to all of the member APs. When you exit
cluster mode, configuration commands revert to applying only to the AP to which
you are connected.
The Clusters window displays a summary of defined clusters and members.
Figure 192. Clusters
Clusters are discussed in the following topics:
Cluster Management
Cluster Management
Clusters are displayed and managed in the single Cluster Management window.
This window allows new clusters to be created and APs to be added or removed
from clusters.
The Clusters window provides you with an overview of all clusters that have
been defined for this AP, and the APs that have been added to each. Clusters are
listed and cluster members may be displayed by expanding a cluster entry. Each
AP entry displays its IP Address, Username, and Password. All existing clusters
An XR-500 or XR-1000 Series AP cannot act as the Cluster controller. It
will operate correctly as a member of a cluster.
An XR-500 or XR-1000 Series AP cannot act as the Cluster controller. It
will operate correctly as a member of a cluster.
To Next Page
Loading...
