Xirrus XD Series User Manual

Wireless Access Point
488 The Command Line Interface
snmp
The snmp command [MyAP(config-snmp)#] is used to enable, disable, or
configure SNMP.
Command Description
trap Configure traps for SNMP. Up to four trap
destinations may be configured, and you may
specify whether to send traps for authentication
failure.
FORMAT:
snmp trap
v2 Enable SNMP v2.
FORMAT:
snmp v2
v3 Enable SNMP v3.
FORMAT:
snmp v3

Xirrus XD Series Specifications

General

Category	Wireless Access Point
Wireless Standards	802.11a/b/g/n/ac
Power over Ethernet (PoE)	802.3af/at
Frequency Bands	2.4 GHz, 5 GHz
MIMO Technology	4x4 MIMO
Mounting Options	Ceiling, wall
Security	WPA2
Management	Xirrus Management System (XMS)
Model	Xirrus XD Series