XP0100 Enterprise IP Phone Using the Advanced Phone Functions
Xorcom Ltd. 40 www.xorcom.com
Reset to Factory
You should reset the phone only in this case: the phone configuration was changed and
the phone is not functioning anymore. To maintain the configuration of the phone, you
need your system administrator or service provider’s advice.
To reset to factory via phone user interface:
1) Press ->Settings->Advanced.
2) Enter the password required, scroll to Reset Factory and then press .
3) You are prompted to confirm the change, press to reset to factory settings or
to cancel.
It takes a few minutes to reset the phone, please do not power off during the
process, or it will cause flash memory error.
To reset to factory via web user interface:
1) Click on Phone->Upgrade.
2) Click Reset To Factory.
Note:
1. The reset to factory option must in the admin mode.
2. If you confirm to reset to factory, contact list, call history, account settings, etc will
be lost. You need to export the configuration first if you still want to import the old
configurations after reset. Or your phone must be configured manually unless mass
provisioning is used!
Export/Import Configuration File
To Export/Import configuration file via web user interface:
1) Click on Phone->Configuration.
2) Scroll to Export / Import Config field.
3) Click Export to export the file to your local system.
4) Click Browse and select a configuration file on your local system, and then click
Import to import the configuration file.
It takes a few minutes to finish the process, please do not power off during the
process, or it will cause flash memory error.
Firmware Update
The phone is delivered with pre-installed firmware. If you require updating the phone’s
firmware, please contact your system administrator. You can only update the firmware
via web user interface.
To Next Page
Loading...
