Xorcom XP0100 - Url; Snmp

XP0100 Enterprise IP Phone Using the Advanced Phone Functions
Xorcom Ltd. 55 www.xorcom.com
URL
If the key is configured as URL, then pressing this key, you can send HTTP requests to
a web server.
To assign the key as URL via web user interface:
1) Click on DSS Keys->Memory Keys.
2) Select the desired DSS key.
3) Select URL from the pull-down list of Type.
4) Enter the number you want to set as URL in the Value field.
5) Click Confirm to save the change.
SNMP
Simple Network Management Protocol (SNMP) is an Internet-standard protocol for
managing devices in IP networks. It is used mostly in network management systems to
monitor network-attached devices for conditions that warrant administrative attention.
SNMP exposes management data in the form of variables on the managed systems,
which describe the system configuration. These variables can then be queried (and
sometimes set) by managing applications. For further information, you can refer to
http://en.wikipedia.org/wiki/SNMP.
By default, the phone does not accept SNMP requests. This is necessary because SNMP
might introduce unwanted security threats. The phone only supports the GET request of
SNMP. SET or other requests are not supported. To enable SNMP, you must specify what
IP addressed may send SNMP requests to the phone.
To configure SNMP via web user interface:
1) Click on Network -> Advanced.
2) Scroll to SNMP field and select Enabled from the pull-down list of Enable.
3) Enter the port and trusted address in the Port and Trusted Address fields.
4) Click Confirm to save the change.
Note:
1. You may use several trusted IP addresses separated by space.
For example, “192.168.3.10 192.168.3.78” will allow accesses from the two listed
IP addresses.
2. Wildcards are not supported here.