Operation of Your Console
Console
Power Up
Power the elliptical on by plugging it into an appropriate wall outlet. When power is
connected to the elliptical and the switch is on, the console will automatically power up. If
there is no input to the console for 30 minutes, the console will go to stand-by mode to save
energy. To turn the console on press any key.
When initially powered on the console will perform an internal self-test. During this time
all the lights will turn on. When the lights go off the dot matrix display will show a software
version (i.e.: VER 1.0) and the time and distance windows will display an odometer reading.
The odometer reading displays how many hours the elliptical has been used and how many
virtual miles the elliptical has gone.
The odometer will remain displayed for only a few seconds then the console will go to the
start up display. The dot matrix display will be scrolling through the different workout profiles
of the programs and operating instructions. You may now begin to use the console.
NEVER operate this elliptical without reading and completely understanding the results of
any operational change you request from the computer.
Understand that changes in resistance do not occur immediately. Set your desired level on
the computer console and release the adjustment key. The computer will obey the
command gradually.
To Next Page
Loading...
Need help?
General
