Xterra UB120 - Handlebar Assembly; Computer Assembly

customerservice@dyaco.ca
DyacoCanadaInc2020

11

5 HANDLEBAR ASSEMBLY
1. Attach handlebar (4) to the front post (2) and secure
with two sets of Allen screws (10) and Spring
washer (21).
6 COMPUTER ASSEMBLY
1. Remove the Grommet (28) from the Front
Post (2).
2. Insert hand pulse wires (27) into grommet (28)
and pull out from the top bracket. Connect hand
pulse wires (27) and extension sensor wire (7)
to computer (18).
3. Attach computer (18) to the top bracket of front
post (2). Securing with two screws (16) which are
pre-assembled on the computer (18).
Install the cover for the handlebar (25) over the
Handlebar.
Hardware Step 5
Allen Key (#54）
2 Allen screw (#10)
2 Spring washer (#21)
Hardware Step 6
Allen Key （#54）
Cover for handlebar (#25)