customerservice@dyaco.ca
DyacoCanadaInc2020
10
3 SEAT ASSEMBLY
1. Attach seat (14) to the seat post (3). Securing with
three sets of flat washers (15), and nylon nut (17) which
are pre-assembled on the seat (14).
2. Insert the seat post (3) into main frame (1) and tighten
with the club knob (26).
4 PEDAL ASSEMBLY
1. The left and right pedals (23 & 24) are marked “L” & “R”.
Attach the straps to the pedals. Connect left pedal (23) to the
crank (8) on the left-hand side of the cycle as you sit on it.
Repeat for the right pedal (24).
Note that the right pedal should be threaded on
clockwise and the left pedal on counterclockwise.
Hardware Step 3
Hardware Step 4
Box wrench（#55）
Club knob（#26）
Box wrench（#55）
To Next Page
Loading...
Need help?
General
