customerservice@dyaco.ca
DyacoCanadaInc2020
9
HOW TO CONNECT THE TENSION CONNECTOR
NOTE: If you are not able to hold the Front Post while connecting the cables and wires，
extra help may be needed.
Pull the Upper Tension
Connector backward and
slide the wire through the slot
on the bracket.
Drop down the Connector so
the fitting sits firmly on top of
the bracket.
Slide the Cable wire from the
Upper Tension Connector in
between the opening on the
wire holder on the Lower
Tension Connector.
To Next Page
Loading...
Need help?
General
