AutoProPAD Basic Key Programmer
10
for example, the conditions that some vehicle models need to be reached are as
follows: engine temperature 80℃ to 105℃ , turn off any loads (such as headlights,
air-conditioner, etc.), put accelerator pedal in released position, and etc.
3.2.4. If users can not find the tested vehicle model or electronic control system in the
AutoProPAD Basic test menu, they need to update the software or consult Xtool
technical service department.
3.2.5. Please ensure that only approved XTOOL cables and connectors are used to prevent
damage to the unit.
3.2.6. Before powering off the unit, please ensure that you cancel, complete the current task
or function, and return to the main interface, then power off.
3.2.7. Do not use any excessive force to operate the touch screen.
3.2.8. During long period of non-use, please disconnect the power and turn off the
AutoProPAD Basic unit.
4. Key Programming and Special function
4.1. Menu Options
4.1.1. After the AutoProPAD Basic main unit is connected to the vehicle via main test cable,
Immobilization can be performed. The Immobilization interface is shown as below.
To Next Page
Loading...
