Xtralis XAS-1-US - User Manual

Questions and Answers

J
Jennifer TrujilloAug 3, 2025
What to do if FLOW HI or FLOW LO light is on Xtralis XAS-1-US?
- L
  Leonard MartinAug 3, 2025
  If the FLOW HI or FLOW LO light is illuminated on your Xtralis Smoke Alarm, take the following steps: * Make sure the sampling pipes are correctly installed, the lid is fitted, and the box is fully sealed. * Confirm that the flow calibration procedure has been carried out. * Check and clean the filters. * Verify that the fan is operating normally. * If using flexible tubing, check for pinches or kinks. * For duct applications, ensure the inlet and exhaust tube holes are free from obstructions.
C
Christine WhiteAug 7, 2025
Why is the Xtralis XAS-1-US Smoke Alarm detector unresponsive to smoke tests?
- K
  Kara LeeAug 7, 2025
  If your Xtralis Smoke Alarm detectors are unresponsive to smoke tests, consider the following: * Ensure the sampling pipe is correctly installed and undamaged. * Verify that the recommended baffles are fitted. * Confirm that the recommended test method is being used. * Try increasing the fan speed and re-testing.
M
Mrs. Jill PetersonAug 11, 2025
What to do if the flow reading on Bargraph display moves erratically on Xtralis Smoke Alarm?
- A
  Alyssa HooverAug 11, 2025
  If the flow reading on the bargraph display of your Xtralis Smoke Alarm moves erratically, decrease the flow sensitivity setting and recalibrate the air flows.
R
reginald67Aug 15, 2025
What to do if flow reading on Bargraph is unresponsive to broken or blocked pipe on Xtralis XAS-1-US?
- F
  fordmatthewAug 15, 2025
  If the flow reading on the bargraph display of your Xtralis Smoke Alarm is unresponsive to a broken or blocked pipe, increase the flow sensitivity setting and recalibrate the air flows.
S
Susan SmithAug 20, 2025
How to fix Xtralis XAS-1-US Smoke Alarm with no lights on display and fan not running?
- D
  Dr. Gary MckinneyAug 20, 2025
  If there are no lights on the display and the fan is not running on your Xtralis Smoke Alarm, check the following: * Ensure the supply leads are correctly oriented. * Make sure that the BAT FUSE is correctly seated in the socket and that the fuse is not blown.
C
Christine Baker DVMAug 25, 2025
How to fix Xtralis XAS-1-US Smoke Alarm with no lights on display but fan running OK?
- Z
  Zachary NealAug 25, 2025
  If there are no lights on the display of your Xtralis Smoke Alarm, but the fan is running OK, ensure that the ribbon cable is fully seated into the main and display boards.
B
baileystaffordAug 28, 2025
Why is the power light flashing on my Xtralis XAS-1-US?
- A
  Angel AndersonAug 28, 2025
  If the power light is flashing on your Xtralis Smoke Alarm, ensure the supply to the BATTERY connector is within limits.