IMPORTANT SAFETY INSTRUCTIONS
3
WARNING
Please carefully read and retain all safety warnings and instructions. Non-compliance
with these guidelines could lead to electric shock, fire, and/or grave injury.
Not every potential scenario can be anticipated and detailed in this manual. Operators are
expected to exercise common sense and caution, which are indispensable and beyond the
scope of this product's design. Thoroughly review and comprehend all ASSEMBLY AND
OPERATION INSTRUCTIONS before use. Ignoring safety regulations and basic precautions
could lead to severe injury.
Maintain a minimum distance of 6 FEET (1.8 METERS) between the pool and any electrical
outlets to minimize electric shock risk. Keep portable appliances at least 5 FEET (1.5
METERS) away from the pool.
• To minimize the risk of injury, do not allow children to use this product unless they are under
close supervision at all times.
• Do notbury the power cord. Position it to avoid damage from lawn mowers, hedge trimmers,
and similar equipment.
• To prevent electric shock, replace a damaged cord immediately.
• Avoid electric shock. Do not connect the unit to an electrical supply with an extension cord;
instead, ensure a properly located outlet is available.
• Preserve these warnings for reference.
• This product is exclusively for use with SWIMMING POOLS.
• For ongoing protection against electric shock, service the unit with identical replacement
parts only.
• To prevent electric shock, connect this item solely to a grounding type receptacle.
GENERAL SAFETY
• Ensure the circuit breaker is switched to the ON position.
• Check that water is flowing smoothly and that the pool pump is operational.
• Set the desired water temperature. Upon doing so, the fan will activate immediately, and the
compressor will engage after a brief 3 to 4-minute interval.
• Once the compressor is operational, the "heating" light on the control panel (refer to
“ERROR CODES" section) should be illuminated. It's typical for the heater to function con-
tinuously for the full 24 hours on its first run.
• Observing water dripping from the base of the unit is a regular occurrence; this is simply
condensation forming.
INITIAL STARTUP
To Next Page
Loading...
