en – Original Instructions
6 ecocirc PRO – Installation, Operation and Maintenance Manual
Qualified personnel
WARNING:
This unit must be used only by qualified users. Qualified users are people able
to recognise the risks and avoid hazards during installation, use and
maintenance of the unit.
Inexperienced users
this product may be used by children aged 8 years and
above and persons with reduced physical, sensory or menta
l capabilities, or
who lack experience and knowledge, provided that they are being
supervised and have been instructed on how to use it safely, and understand
the hazards involved. Children must not play with the product. Cleaning and
maintenance must not be carried out by children without supervision.
For countries outside the EU:
this product is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or
who lack experience and knowledge, unless they are being supervised and
have been instructed on how to use it by a person respon
sible for their safety.
Children should be supervised to ensure that they do not play with the
product.
General safety rules
• Always keep the work area clean.
• Pay attention to the risks presented by gas and vapours in the work area.
• Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash hazards.
• Always bear in mind the risk of electrical accidents and burn injuries.
Safety equipment
It is recommended to use the proper safety equipment within the work area:
• Hard hat
• Safety goggles
• Protective shoes
• Protective gloves
• Hearing protection
Electrical connections
Electrical connections must be made by certified electricians in compliance with all international,
national, state, and local regulations.
Precautions before work
Observe these safety precautions before you work with the product:
• Make sure that you have a clear path of retreat.
• Allow all system and pump components to cool before you handle them.
• Make sure that the product has been thoroughly cleaned.
• Disconnect and lock out power before you service the pump.
Precautions during work
Observe these safety precautions when you work with the product:
• Rinse the components in water after you disassemble the pump.
• Do not exceed the maximum working pressure of the pump.
• Do not open any vent or drain valve or remove any plugs while the system is pressurized.
Make sure that the pump is isolated from the system and that pressure is relieved before you
disassemble the pump, remove plugs, or disconnect piping.
To Next Page
Loading...
