QUICK GUIDE
WQG-10029-01
Front Panel Display and Buttons
The display is an eight digit transmissive red LCD,
0.46” high. A green LCD is also available. For
outdoor or high ambient light conditions, reflective
readouts will be supplied.
SELECT: Toggles display and advances menu
selection in the programming mode.
RESET: Resets counter to zero if enabled and
changes display in programming mode.
COUNT DISPLAY: 8-digit, display flashes “tot” over
for an overflow condition.
RATE DISPLAY: 6-digit with an enunciator “R” on the
left side.
Memory
Non-volatile E2PROM memory retains all
programming parameters and the count value when
power is removed.
Act-Pak® Electronic Instrumentation
Models 1100D and 1100DN Quick Guide
Electrical Connections
1. Complete all connections to the metering device
and instrument before applying power.
2. If it becomes necessary to disconnect any of these
connections, first remove the AC power to the
instrument.
Meter or Signal Output
Terminal
Number
Function Wire Color
Switch Inputs
(Belden 8760)
Wire Color Solid
State Inputs
(Belden 8770)
13 +12VD C No Connection Red
16 Input Signal White White
14 Ground Black Black
15 Shield Bare (Shield) Bare (Shield)
Act-Pak® Remote Monitoring is an automatic control translator package. The Model 1100D
is a standard NEMA1 free standing or panel mountable enclosure. The Model 1100DN is
a NEMA4X wall mountable fiberglass enclosure. Each Act-Pak device accepts pulses or
contact closures from metering devices and provides a variety of outputs.
Physical Size/Weight
Model 1100D 1100DN
Length 8-3/4” (22 cm) 8-1/2” (21.6 cm)
Height 3-1/8” (8 cm) 4-1/4” (11 cm)
Width 8-9/16” (23 cm) 6-1/2” (16.5 cm)
Weight 4 lbs. (1.8 kg) 4 lbs. (1.8 kg)
Typical Series 1100 Act-Pak Wiring Connection Diagram
To Next Page
Need help?
General
