Need help?Do you have a question about the Yaesu FT-100 Micro Mobile and is the answer not in the manual?
General| Supply Voltage | 13.8 V DC ±15% |
|---|---|
| Frequency Range | 144-148 MHz, 430-450 MHz |
| Modes | AM, FM |
| IF Frequencies | 455 kHz |
| Sensitivity | 0.16 μV |
| Weight | 3.3 lbs (1.5 kg) |
| RF Power Output | HF/50 MHz: 100 W, 144 MHz: 50 W, 430 MHz: 20 W |
Instructions for connecting the DC power supply to the FT-100 transceiver.
Guidelines for selecting and connecting antennas for optimal system performance.
Connecting various external accessories like amplifiers and TNCs to the transceiver.
The primary tuning control for frequency and menu adjustments.
Accessing various functions and menu items via the FUNC key.
Used for tuning, memory selection, and function setting.
Basic steps to turn on, select bands, and set modes for initial operation.
Choosing operating modes such as SSB, CW, AM, and FM.
Using the FUNC key to access various operating functions and menus.
Choosing appropriate bandwidths for SSB, CW, and AM modes.
Configuring tuning steps for frequency selection.
Preventing accidental changes to settings by locking the controls.
Adjusting receiver frequency offset for clear reception.
Configuring the receiver's automatic gain control for optimal performance.
Activating the noise blanker to reduce impulse noise.
Adjusting the CW sidetone pitch for comfortable listening.
Configuring the DSP bandpass filter for improved selectivity.
Tuning the DSP CW peaking filter for enhanced signal clarity.
Applying DSP noise reduction to improve signal-to-noise ratio.
Using the DSP notch filter to eliminate unwanted carrier signals.
Adjusting the transmitter's output power for different bands and modes.
Tailoring microphone audio characteristics using the DSP equalizer.
Procedures for transmitting in Single Sideband (SSB) mode.
Using Voice Operated Transmission (VOX) for hands-free transmitting.
Optimizing voice quality using the AF speech processor.
Operating in Continuous Wave (CW) mode for Morse code transmission.
Procedures for operating in Frequency Modulation (FM) mode.
Monitoring the SWR (Standing Wave Ratio) of the antenna system.
Using repeaters for extended communication range.
Setting up CTCSS tones for selective squelch and repeater access.
Utilizing Digital Code Squelch (DCS) for selective communication.
Sending DTMF tones for control purposes or autopatch operation.
Using the ARTS system for proximity alerts and station identification.
Operating on separate transmit and receive frequencies.
Operating in various digital modes like RTTY and Packet.
Transmitting and receiving packet data over HF and FM bands.
Using the FT-100 for emergency communications on the specified frequency.
Steps for tuning the ATAS-100 antenna for optimal SWR.
Storing and recalling antenna tuning data using the FC-20's memory.
Storing and recalling split-frequency pairs for DX operations.
Utilizing pre-programmed 'HOME' channels for quick access.
Utilizing the PMS feature for scanning specific memory groups.
Navigating and configuring the FT-100's extensive menu system.
Steps to reset the transceiver to factory default settings.
To Next Page
