To Next PageTo Next Page
Need help?Do you have a question about the Yaesu FT-1000MP and is the answer not in the manual?
General| Receiver Type | Double conversion superheterodyne |
|---|---|
| Impedance | 50 ohms |
| Power Supply | 13.8 VDC |
| Image Rejection | >70 dB |
| Modes | SSB, CW, AM, FM |
| Receiver Sensitivity | 0.16 µV (10 dB S/N) |
| IF Rejection | 70 dB |
| IF Bandwidth | 2.4 kHz |
An overview of the transceiver, its features, and Yaesu's commitment to quality.
Covers frequency range, stability, modes, power, sensitivity, and selectivity.
Detailed pinout diagrams for various transceiver connectors including MIC, CAT, and data jacks.
Details TCXO units, microphones, loudspeakers, and headphones for improved performance.
Information on the DVS-2 recorder and optional IF crystal filters for enhanced reception.
Steps for initial inspection, power connection, and voltage setting.
Guidance on transceiver placement, ventilation, grounding, and antenna setup.
Details POWER, MOX/VOX, AGC, PHONES, KEY, MIC/PROC controls and indicators.
Explains VFO knobs, MODE, FAST, CLAR, EDSP, SUB VFO, and CW/Keyer controls.
Explains MAIN/SUB receiver display indicators, bargraph meter, and multi-display windows.
Details controls accessible under the top panel, including VOX and audio adjustments.
Covers ANT, REMOTE, CAT, DVS-2, PACKET, and RTTY connectors.
Details PTT, EXT ALC, SPKR, AF OUT, GND, BAND DATA, +13.5V, RX ANT, TRV, TX GND.
Information on DC cable sockets, AC line cords, and fuse holders.
Initial setup, tuning methods, band selection, and key beeper configuration.
Covers operating modes, reverse CW, and display settings.
Understanding tuning scales, peak-hold, and expanded tuning displays.
Utilizing IF filters, WIDTH, SHIFT, AGC, and Noise Blanker for QRM.
Adjusting RF Gain and setting Noise Blankers for optimal reception.
Covers SSB/AM/FM transmission, VOX setup, and transmitter monitor.
Details CW transmission, electronic keyer modes, ACS, and pitch settings.
Adjusting AM/FM transmission parameters and carrier point offset.
Setting up and operating RTTY and AMTOR modes with a TNC.
Details 300-baud and 1200-baud packet operations and settings.
Information on mitigating radio frequency interference from computers.
Explains EDSP for audio enhancement, noise reduction, and filtering.
Details EDSP bandpass filters, notch filter, and their configurations.
Covers memory organization, storing VFO data, and programming channels.
Explains memory grouping, recalling, operating, and tuning memories.
Details VFO and Memory scanning, skip features, and resume modes.
Using the Sub VFO, dual reception, VFO tracking, and split operation.
Sideband and Bandwidth diversity reception for improved signal copy.
Operating via remote control, contest keyer functions, and keypad selections.
Features and operation of the digital voice recorder for message storage.
Interconnecting and operating with linear amplifiers and phone patches.
Connecting and operating transverters for frequency extension.
Connecting and controlling the transceiver via computer using CAT commands.
Guide to accessing and configuring transceiver settings via the menu system.
Detailed reference for all programmable functions, ranges, and defaults.
Guides for installing TCXO units and optional IF filters.
Procedures for battery replacement, fuse replacement, and tuning knob torque.
Steps to enable and set up DC power operation for the transceiver.
