Need help?Do you have a question about the Yaesu FT-1000 and is the answer not in the manual?
General| Receiver Type | Double conversion superheterodyne |
|---|---|
| Antenna Impedance | 50 ohms |
| Supply Voltage | 13.8 V DC |
| Modes | SSB, CW, AM, FM |
| Selectivity | 2.4 kHz (SSB), 500 Hz (CW), 6 kHz (AM), 15 kHz (FM) |
| Current Drain | 20 A |
Covers initial checks, AC power connection, and fuse verification.
Explains how to change the primary transformer winding for different AC voltages.
Describes the POWER button and 2-position pushbutton functions like RX ANT, MOX, VOX.
Covers FRONT END selector and RF GAIN control for receiver sensitivity.
Details PROC DRIVE, SQL NB, AF RF, MIC, and PHONES controls.
Details DOWN/UP, NOTCH, APF, VFO-A-M, and VFO/MEM controls.
Explains MODE selection buttons and FAST tuning function.
Describes the Main (VFO-A) tuning knob and its operation.
Advises on optimizing receiver sensitivity using FRONT END and RF GAIN controls.
Explains AGC selection and using noise blankers for interference reduction.
Details using BANDWIDTH, SHIFT, and WIDTH controls for interference suppression.
Explains using the monitor and setting up the speech processor.
Details setting up VOX GAIN, ANTI-TRIP, and DELAY controls.
Guides on setting up for SSB and AM transmission, including MIC and RF PWR.
Details initial setup for CW transmission, including DRIVE and RF PWR.
Covers FM transmission and specific features for repeater operation.
Explains CW break-in and using the internal electronic keyer.
Explains controlling Sub VFO B, band selection, and subband features.
Guides on activating and configuring dual-channel reception.
Details activating and using split transmit/receive operation.
Guides on storing frequency, mode, and settings into memory channels.
Explains how to view and recall memory channel data.
Introduces CAT system for computer control of transceiver functions.
Details the 5-byte command block format and parameter types.
To Next Page