Do you have a question about the Yaesu FT-101 and is the answer not in the manual?
Power Supply | AC 117 / 234 VAC, DC 13.5 VDC |
---|---|
Dimensions | 13.1(W) x 5.9(H) x 11.4(D) inches |
Weight | 28.6 lbs |
Receiver Sensitivity | 0.5 uV for 10 dB S/N |
IF Frequencies | 455 kHz |
RF Power Output | 180 W (PEP SSB), 160 W (CW) |
Voltage | AC 117/234 V, 50/60 Hz |
General guidelines for transceiver installation.
Instructions for setting up the transceiver as a base station.
Procedures for installing the transceiver in a mobile environment.
Guidance on antenna connection and impedance matching.
VFO Select, Tuning Knob, Band Switch, Preselector, Clarifier controls.
RF/AF Gain, Mic Gain/Carrier, Mode Switch, MOX-PTT-VOX.
Noise Blanker, RF Attenuator, Calibrator, Phone, Mic, Meter.
Main Power and Heater switches.
AF-IN, IF OUT, SP, AUX, RF OUT connections.
PTT, PATCH, KEY, ACC, EXT VFO jacks.
GND, ANT, FUSE, FAN, LAMP FUSE, POWER ports.
Pre-operation checks and how to read frequency dials.
Procedure for calibrating the receiver frequency.
Initial steps before final transmitter tuning.
Steps for achieving maximum transmitter output.
Description of High Frequency and IF units.
Description of Modulator, Audio, Regulator units.
Description of VFO, Noise Blanker, and Power Regulator units.
Overview of components within the main chassis.
Description of power supply and preselect circuits.
Description of final amplifier and metering functions.
Instructions for installing the CW filter.
List of necessary test equipment for alignment.
General notes and precautions for alignment procedures.
Alignment for T107, L29, L22, T113, T115, L28, TC30.
Table of DC voltage measurements.
Table of RF voltage measurements.
List of fuse types and ratings.
List of relay types used in the unit.
List of switch types used.
List of crystal specifications.
List of multi-jack types.
List of lamp types.
List of tube socket types.
List of receptacle and jack types.
List of meter types.