Need help?Do you have a question about the Yaesu FT-100 and is the answer not in the manual?
General| Supply Voltage | 13.8 VDC |
|---|---|
| Modes | SSB, CW, AM, FM |
| Power Output | HF/50 MHz: 100W, VHF: 50W |
| Current Drain | TX: 22 A |
| Receiver Sensitivity | FM: 0.5 μV |
Core specifications including frequency range, emission modes, and power requirements.
Details on transmitter power output, modulation types, and frequency response.
Specifications for receiver sensitivity, selectivity, and audio output characteristics.
Diagrams showing pin assignments for major connectors like MIC, DATA, KEY, and ACC.
Instructions for connecting the DC power source to the transceiver.
Proper grounding techniques for optimal performance and safety.
Guidelines for connecting and optimizing antennas for best performance.
Connecting external accessories like tuners, amplifiers, and TNCs.
Description of buttons, knobs, and indicators on the transceiver's front panel.
Guide to the rear panel connectors and their specific uses.
Initial steps for powering on, basic configuration, and band selection.
Utilizing the FUNC key to access and change transceiver features.
Adjusting transmit power levels and the DSP microphone equalizer.
Procedures for SSB transmission and using the VOX feature.
Operating the transceiver in various CW transmission modes.
Using the built-in electronic keyer and message memory functions.
Steps to perform factory default resets for the transceiver.
Lists common problems and their potential causes and solutions.
To Next Page
