To Next PageTo Next Page
Need help?Do you have a question about the Yaesu FT-1900R and is the answer not in the manual?
General| Frequency Range | 144-148 MHz |
|---|---|
| Mode | FM |
| Channels | 200 |
| Supply Voltage | 13.8V DC |
| Antenna Impedance | 50 ohms |
| Type | Mobile |
| Output Power | 50W |
| Channel Steps | 5, 10, 12.5, 15, 20, 25, 50 kHz |
| Sensitivity | 0.2 μV (12dB SINAD) |
Inspect transceiver for damage and loose components after unpacking.
Essential safety precautions for operating and installing the transceiver.
Guidelines for selecting and connecting a 50-ohm antenna for optimal performance.
Procedure for mounting the transceiver in a vehicle.
Information for integrating the FT-1900R into a base station setup.
Used for tuning, memory selection, and function settings.
Procedure to power the transceiver on and off using the PWR key.
How to transmit using the PTT switch and select power levels.
Manually set repeater shift direction and offset (600 kHz default).
Auto-activates repeater shift when tuning to standard repeater subbands.
Setup for CTCSS tone encoding/decoding for repeater access.
Setup for Digital Code Squelch (DCS) encoding and decoding.
Store frequency, shift, tones, and power level into memory channels.
Store separate transmit and receive frequencies for repeater pairs.
Organize memories into up to eight Memory Banks.
Start/stop scanning using UP/DWN keys, scan VFO/Memory.
Periodically check a designated Memory Channel for activity.
Search for active frequencies and store them in Smart Search memory.
Clear all memories and settings to factory defaults.
