Yaesu FT-65E - Tone Calling (1750 Hz)

Tone Calling (1750 Hz)
For operation in counties that require a 1750-Hz burst tone for repeater
access (typically in Europe), the MONI/T.CALL key may be programmed to
serve as a “Tone Call” key instead. Use Set Mode item “19 MON/T-CL”, to
change the conguration of this key.
Display Description
MONITOR
(default setting (USA and Asian
version))
Pressing the MONI/T.CALL key opens
the receiver noise squelch.
T-CALL1750
(default setting (European
version))
Pressing the MONI/T.CALL key acti
-
vates the 1750 Hz burst tone.
T-CALL2100
Pressing the MONI/T.CALL key acti-
vates the 2100 Hz burst tone.
T-CALL1000
Pressing the MONI/T.CALL key acti
-
vates the 1000 Hz burst tone.
T-CALL1450
Pressing the MONI/T.CALL key acti
-
vates the 1450 Hz burst tone.
1. Press and hold the F key to enter the Set mode.
2. Press the [▲] or [▼] key to select Set Mode item “19 MON/T-CL”.
3. Press the F key to enable adjustment of this Item.
4. Press the [▲] or [▼] key to select a Tone
Calling feature.
5. Press the PTT switch to save the new setting
and return to normal operation.
To access a tone burst controlled repeater, press and hold in the MONI/
T.CALL key for the time duration specified by the repeater owner/operator.
The transmitter will automatically be activated, and the 1750-Hz audio tone
will be superimposed on the carrier. Once the repeater is accessed, release
the MONI/T.CALL key and use the PTT switch to activate the transmitter
thereafter.
28
Repeater Operation
FT-65R/FT-65E Operating Manual