56 FT-891 Advance Manual
Scanning Operation
Scan Resume Options
The manner in which the scanner resumes after it has paused on a signal may be selected
by using Menu Mode “05-16
[
MIC SCAN RESUME
]
”. The default “TIME” (5 sec) setting
will cause the scanner to resume scanning after five seconds; however the scan setting
may be changed to resume only after the received signal has dropped out.
To choose the Scan-Resume mode:
1. Press and hold in the
[
F
]
key for one second
to activate the Menu mode.
2. Rotate the MULTI function knob to select
Menu Mode “05-16
[
MIC SCAN RESUME
]
”.
3. Press the MULTI function knob, and then
rotate it to select the desired Scan-Resume
mode.
PAUSE: During automatic scanning, the
scanner will hold until the signal
disappears.
TIME: If the signal does not disappear within five seconds, the scanner will resume
scanning for the next active channel (frequency). If there is no signal, the
scanner continues scanning automatically.
4. Press the MULTI function knob to save the new setting.
5. Press the
[
F
]
key to exit the Menu mode and resume normal operation.
To Next Page
Loading...
Need help?
General
