7
no gap
6
Loosely install
stabilizer nut
and bolt.
B
A
,167$//352'8&7
ALIGN
1
Install your hitch product into the BackSwing by following the
instructions that came with that product. Then tighten the
stabilizer bolt and nut on the BackSwing until snug.
Use caution when closing the latch to avoid
hooking the bottom of the latch bracket.
Always close the latch. There should be no gap at the
point indicated below when the latch is closed. If a gap
exists, see page 6 for instructions to tighten safety latch.
To Next Page
Loading...
