100 YRM 1015 Load Wheels
1. LOAD WHEEL
2. FITTING
3. ROLLER
4. BEARING
5. BUSHING
6. AXLE
7. FITTING
8. PIN
Figure 4. Load Wheel and Link Assembly
7. Remove all old lubricant. Clean and inspect all
parts. Replace all defective parts.
INSTALL
1. Prelubricate the bearings with the recommended
grease. Install the bearings in the load wheel.
2. Align the load wheel and bearings inside the link
and insert the axle shaft.
3. Install the roll pin in the link and through the axle
shaft.
4. Raise the load wheels. Lubricate the load wheel.
5. Install the battery in the battery compartment and
connect the battery.
6. Remove the blocks from under the forks and from
eachsideofthedrivetire. TurnthekeytotheON
positionandusethelowerbuttontolowerthelift
truck to its minimum height. The truck should lift
and lower evenly.
7. Test the operation of the motorized hand truck be-
fore returning the truck to service.
The function of the load wheels is further explained in
Lifting Mechanism 4000 YRM 1008.
7
To Next Page
Loading...
Need help?
General
