11
Mounting the Door/Window Contact
1. The sensor should be on the frame while the magnet
should be on the door/window.
Clean the mounting surface with a suitable degreaser
agent. Please note that some surfaces may be unsuitable
for mounting using the adhesive pads. Please use screw
mounting in these cases.
Mounting PIR Camera
Testing
The gap between the magnet and sensor should be no more
than 10mm when closed. Test to see whether the magnet is
in range of the sensor: before mounting hold the magnet and
sensor in place and then pull them apart. If the sensor LED
lights up it implies the two items are within range.
To Next Page
Loading...
Need help?
General
