15
All accessories (except SR-PC and
SR-PVC) are pre-set to “entry” mode.
When the system is rst armed, users will have 30
seconds to exit the building. If the system is already
armed, triggering any sensors will cause an entry
countdown to begin.
SR-PC/SR-PVC’s default setting is “Burglar only”, i.e.
immediate triggering during full arm and sleep during
Part Arm. This is done to conserve battery life.
To change the exit and entry timer, please enable via
App -> “Settings” -> “System Settings”
Default Settings
6
Supervision is set to disabled as default (recommended off).
Please note that having supervision enabled could reduce the battey life of your devices.
This feature should only be used by a professional installer to check for outage and malfunctions with
your devices. Incorrect usage would lead to supervision failure message showing on the app.
With the exception of the PIR Image Camera, PIR Video Camera and Smoke Detector (which are always
on), the other accessories need to have supervision manually enabled on the device use the app to
facilitate this feature.
Supervision can be enabled via Settings > System Settings > General Conguration.
It is possible to arm the system with
“open” Door/Window Contact
(i.e. windows open).
You will be prompted in the App when trying to arm with your door/window open.
Burglar
Home Omit
Entry
Home Access
Disarmed Part-Armed Armed
Key
Triggers
Countdown
Jamming and interference
detection disabled as default.
If jamming and interference is of concern, please
enable via “Controller” -> “Panel Setting”
To Next Page
Loading...
Need help?
General
