button. If the Engine Start button is pressed before the Power
ON/OFF button, the starter will not operate. See Starting
Procedures, Trucks With Keyless Start Option in this sec-
tion, if starter becomes disabled.
When the lift truck has been restarted, it will run for 30 sec-
onds before shutting down again. Cycle the truck power
again to run the lift truck for another 30 seconds. This process
provides enough power for the lift truck to move under its own
power so that it can be moved to a safe location.
Some faults or sensor measurements will not always cause
the engine to shutdown, but will cause the speed of the lift
truck to be restricted, or will either disable or restrict the
truck's hydraulic functions.
When this occurs, the following actions take place:
• The fault number is displayed on the top line of the LCD
screen and a description of truck performance being
decreased is shown on bottom line.
• The Engine Malfunction icon illuminates (see Figure 7 and
Table 1).
• An alarm will sound for 10 seconds.
Take the lift truck to a service technician immediately for
repair if it experiences a decrease in performance.
Engine Modes (Generation 2 ECO-eLo)
NOTE: Three engine modes are available for lift trucks equip-
ped with Kubota 2.5L LPG engine.
NOTE: Lift truck models GC/GLC040VX, GC/GLC050VX,
GC/GLC060VX, GC/GLC070VX, GC/GLC055SVX (C910)
and GP/GLP/GDP040-070VX (D875) initial setting is Normal
(Mode 1).
• ECO-eLo provides lowest available engine torque.
• Normal (Mode 1) provides normal engine torque.
• Performance (Mode 2) provides maximum available
engine torque.
Operating Procedures
73
To Next Page
Loading...
Need help?
General
