Instrument operation
42
running above 3000 rpm and below 7000
rpm.
To activate the cruise assist:
(1) Push the remote control levers forward
to open the throttle until the desired en-
gine speed is reached and both engines
are operating at the same engine speed.
(2) Push the “CRUISE/NO WAKE” (+) button
or “CRUISE/NO WAKE” (–) button. When
the cruise assist is activated, “Cruise”
and the cruise assist setting level will be
displayed under the boat speed.
1 Cruise assist setting level
Once the cruise assist is activated, the set
engine speed can be increased by pushing
the “CRUISE/NO WAKE” (+) button or de-
creased by pushing the “CRUISE/NO
WAKE” (–) button. However, the adjust-
ment is limited to a maximum of 8 incre-
ments above or below the initial cruise
assist setting. Each time a button is
pushed, the engine speed will increase or
decrease approximately 100–200 rpm.
While the cruise assist is activated, the en-
gine speed can also be adjusted by operat-
ing the remote control levers.
To deactivate the cruise assist:
Operate the remote control levers to de-
crease the engine speed to 3000 rpm or less.
When “Cruise” and the cruise assist setting
level disappear, the cruise assist is deactivat-
ed.
Operating the boat with a minimal
wake (no-wake mode)
The no-wake mode is useful for operating the
boat at a steady speed with a minimal wake.
This is especially convenient when traveling
in harbors, channels, or other areas posted
with low speed limits as “no wake zones”.
The no-wake mode can be activated only
when the engines are operating at idle speed.
To activate the no-wake mode:
(1) Put the remote control levers in the TDE
position or forward position so that both
engines are operating at idle speed.
(2) Push the “CRUISE/NO WAKE” (+) but-
ton. When the no-wake mode is activat-
ed, “No Wake” will be displayed under
the boat speed.
1 “No Wake”
The no-wake mode can be set to 3 engine
speeds. To adjust the engine speed while the
no-wake mode is activated, push the
“CRUISE/NO WAKE” (+) button or
“CRUISE/NO WAKE” (–) button.
To deactivate the no-wake mode:
Perform one of the following operations.
SportsBoat_F5K10.book Page 42 Tuesday, September 8, 2020 11:29 AM
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
