Yamaha 255XE 2021 - Display Operation Modes: Float, Running, Single Lever, DRiVE

Instrument operation
47
Operation mode
When the engines are running and both re-
mote control levers are in the neutral position,
the operation mode can be changed by tap-
ping the operation mode button.
1 Mode status
2 Operation mode button
Float mode
Both engines are stopped. “FLOAT-MODE”
is shown for the mode status.
The audio system function and water temper-
ature are shown instead of the port and star-
board tachometers.
Running mode “ ”
The port and starboard remote control levers
control the throttle and shifting for their re-
spective engines. “RUNNING-MODE” is
shown for the mode status.
Single lever mode “ ”
Both engines are operated at the same en-
gine speed and the throttle and shifting of
both engines are controlled using only the
port remote control lever. “SINGLE-LEVER”
is shown for the mode status.
The starboard remote control lever is not
used.
DRiVE mode “ ” (255XD)
Both engines are operated at the same en-
gine speed and the throttle and shifting of
both engines are controlled using the left and
right throttle/shift paddles. “DRiVE” is shown
for the mode status.
Use this mode to make small throttle adjust-
ments when operating the boat at slow
speeds, such as when docking. (See page 36
for information on the throttle/shift paddles.)
TIP:
 If the remote control levers are moved from
the neutral position to the forward or re-
verse position while the throttle/shift pad-
dles are not being operated, the operation
mode will change to the running mode.
 When the DRiVE mode is activated, the en-
gine speed will be controlled.
AnchorNav
RUNNING MODE
DEPTH
ft .89
9
19
HOUSE
V 13.0
NE
x1000 rpm
SW
H
1 2
SportsBoat_F5K10.book Page 47 Tuesday, September 8, 2020 11:29 AM
Downloaded from ManualsNet.com search engine