Trouble Recovery
75
NOTE:
When the engine does not start with this pro-
cedure, see page 76.
EMU29561
Emergency starting engine
1. Remove the top cowling.
2. Remove the start-in-gear protection ca-
ble from the starter, if equipped.
3. Remove the starter/flywheel cover after
removing the bolt(s).
4. Prepare the engine for starting. For fur-
ther information, see page 31. Be sure
the engine is in neutral and that the en-
gine stop switch lanyard lock plate is at-
tached to the engine stop switch. The
main switch must be “” (on), if
equipped.
5. If equipped the choke knob, pull out it
when the engine is cold. After the engine
starts, gradually return the choke knob
to its home position as the engine warms
up.
6. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
rotor and wind the rope several turns
around the flywheel clockwise.
7. Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
ZMU03429
ZMU03425
ZMU03139
ZMU03427
ZMU03428
To Next Page
Loading...
