Periodic maintenance and adjustment
7-32
7
EAU24215
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screws.
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
[ECA10682]
EAU24331
License plate light
If the license plate light does not come
on, have a Yamaha dealer check the
electrical circuit or replace the bulb.
1. Screw
2. Turn signal light lens
1. Turn signal light bulb
UBP670E0.book Page 32 Monday, July 11, 2016 11:29 AM
To Next Page
Loading...
