4-6
E
3) Run the engine at a fast idle for 10~15
minutes supplying fresh water.
4) Just prior to turning off the engine,
quickly spray “Yamaha Stor-Rite Engine
Fogging Oil” (Part No. LUB-STRRT-12-
00) alternately into the silencer cover.
When properly done, the engine will
smoke excessively and almost stall.
5) Remove the flushing attachment and
wipe off any excess water.
6) Install the top cowling and the propeller.
NOTE:
@
A flushing attachment is available from a
Yamaha dealer.
@
EMU00349
Lubrication
1) Remove the spark plug(s). Spray a
Yamaha “Stor-Rite Engine Fogging Oil”
into each cylinder for 10 seconds.
Grease the spark plug threads and rein-
stall the spark plug(s) and torque to
proper specification. (Refer to the
“CLEANING AND ADJUSTING SPARK
PLUG”).
2) Turn the engine over with the stop lan-
yard disconnected to work the fogging
oil into the piston rings.
3) Change the gear-case oil. (Refer to
“CHANGING GEAR OIL”). Inspect the
oil for the presence of water which indi-
cates a leaky seal. Seal replacement
should be performed by an authorized
Yamaha dealership prior to use.
4) Grease all grease fittings. (Refer to the
“GREASING”)
E_69J10.book Page 6 Monday, May 28, 2001 9:52 AM
To Next Page
Loading...
