Instruments and indicators
31
Stop the engine immediately if the buzzer
sounds and the overheat alert device has ac-
tivated. Check the cooling water inlet for clog-
ging.
NOTICE
ECM01592
● Do not continue to run the engine if the
overheat-alert indicator blinks. Serious
engine damage will occur.
● Do not continue to operate the engine if
a alert device has activated. Consult
your Yamaha dealer if the problem can-
not be located and corrected.
EMU36150
Water separator alert
This indicator will blink if water has accumulat-
ed in the water separator (fuel filter) while
cruising. In such an event, stop the engine im-
mediately and see page 76 of this manual to
drain the water from the fuel filter. Get back to
the port soon and consult a Yamaha dealer
immediately.
NOTICE
ECM00910
Gasoline mixed with water could cause
damage to the engine.
EMU36160
Engine trouble alert
This indicator will blink if the engine malfunc-
tions while cruising. Get back to the port soon
and consult a Yamaha dealer immediately.
NOTICE
ECM00920
In such an event, the engine will not oper-
ate properly. Consult a Yamaha dealer im-
mediately.
EMU36170
Low battery voltage-alert
If the battery voltage drops, the low battery
voltage-alert indicator and the battery voltage
value will start to blink. Get back to the port
soon if the low battery voltage-alert device
has activated. For charging the battery, con-
sult your Yamaha dealer.
EMU36240
6Y8 Multifunction speedome-
ters
The speedometer unit shows the boat speed
and has functions of fuel meter and system
voltage display. The chosen display is select-
ed by using the “” (set) and “” (mode)
buttons as described in this section. In addi-
ZMU05423
ZMU05425
ZMU05427
U6D625E0.book Page 31 Thursday, March 13, 2008 9:06 AM
To Next Page
Loading...
