Operation
40
EMU27151
Engine
● Check the engine and engine mounting.
● Look for loose or damaged fasteners.
● Check the propeller for damage.
● Check for oil leaks.
EMU36490
Flushing device
Check that flushing device’s garden hose
connector is securely screwed on to the fitting
on the bottom cowling. NOTICE: If the flush-
ing device is not properly connected, cool-
ing water can leak out and the engine can
overheat during operation.
[ECM01800]
EMU36961
Install cowling
1. Be sure that all cowling lock levers are re-
leased.
2. Be sure that the rubber seal is seated all
the way around the engine.
3. Place the cowling on top of the seal.
4. Check to be sure the rubber seal fits cor-
rectly all the way around the engine.
5. Move the levers to lock the cowling as
shown. NOTICE: If the cowling is not
installed correctly, water spray under
the cowling can damage the engine, or
the cowling can blow off at high
speeds.
[ECM01990]
After installing, check the fitting of the top
cowling by pushing it with both hands. If the
top cowling is loose, have it repaired by your
Yamaha dealer.
1. Lower level mark
2. Oil dipstick
3. Upper level mark
1. Fitting
2. Flushing device
ZMU06166
12
ZMU06131
ZMU06132
U6D625E0.book Page 40 Thursday, March 13, 2008 9:06 AM
To Next Page
Loading...
