3-8
GB
ON
STARTOFF
701045
EMU00247*
PROCEDURE FOR REMOTE
CONTROL MODEL
4) Place the remote control lever in the
Neutral position.
NOTE:
The start-in-gear protection device pre-
vents the engine from starting except
when in Neutral.
5) Attach the engine stop switch lanyard
to a secure place on your clothing, or
your arm or leg. Then, install the lock
plate on the other end of the lanyard
in the engine stop switch.
w
8 Attach the engine stop switch lanyard
to a secure place on your clothing, your
arm or leg while operating.
8 Do not attach the lanyard to clothing
that could tear loose. Do not route the
lanyard where it could become entan-
gled, preventing from functioning.
8 Avoid accidentally pulling the lanyard
during normal operation. Loss of
engine power means the loss of most
steering control. Also, without engine
power, the boat could slow rapidly.
This could cause people and objects in
the boat to be thrown forward.
6) Turn the main switch to “ON”.
NOTE:
When the main switch is first turned on,
all warning lamps flash for a few seconds.
If a light does not flash, replace the bulb.
67F-9-76-A0-3 4/1/02 4:04 PM Page 18
To Next Page
Loading...
Need help?
General
