Operation
47
(2) Move the remote control lever / gear shift
lever firmly and crisply forward (for for-
ward gear) or backward (for reverse gear)
[about 35° (a detent can felt) for remote
control models]. Be sure to check that
the tilt lock lever is in the lock/down po-
sition (if equipped) before operating in re-
verse.
Tiller handle models: The gear shift lever op-
erates only when the throttle grip is in the fully
closed position.
To shift from in gear (forward/reverse) to neu-
tral
(1) Close the throttle so that the engine
slows to idle speed.
(2) After the engine is at idle speed in gear
move the remote control lever / gear shift
lever firmly and crisply into the neutral
position.
U6FW76E0.book Page 47 Tuesday, November 23, 2021 7:37 AM
To Next Page
Loading...
