Operation
53
(3) Place the tilt lock lever (if equipped) in the
release/up position.
(4) Pull up the shallow water lever (if
equipped).
(5) Hold the rear of the top cowling with one
hand and tilt the engine up fully.
(6) Push the tilt support knob into the clamp
bracket. Or the tilt support bar will turn to
the lock position automatically. NO TICE:
Do not use the tilt support lever or
knob when trailering the boat. The
outboard motor could shake loose
from the tilt support and fall. If the mo-
tor cannot be trailered in the normal
running position, use an additional
support device to secure it in the tilt
position. For more detailed informa-
tion, see page 58.
[ECM01642]
EMU44610
Procedure for tilting up (power tilt
models)
(1) Place the remote control lever in neutral.
(2) Press the power tilt switch ā ā (up) until
the outboard motor has tilted up com-
pletely.
(3) Push the tilt support knob into the clamp
bracket to support the engine.
WARNING! After tilting the outboard
motor, be sure to support it with the
UP
ZMU01787
U6FW76E0.book Page 53 Tuesday, November 23, 2021 7:37 AM
To Next Page
Loading...
